know About The Best Way To Arlo Camera Setup +1-844-422-0089

Arlo Camera Setup

Here are steps to Set up and sync Arlo Wire-Free cameras:

1. Firstly, unlock the battery compartment by sliding and holding the latch.
2. Then, slide the battery door back and lift it to open the compartment.
3.  After that, insert the batteries and close the battery door.
4. Now, bring the camera within one to three feet (30 to 100 centimeters) of the base station.
5. Do sync the camera to the base station for that:

Whether you are using an Arlo base station, press the Sync button on the side or on the back of the base station for about two seconds and then release the button.
Or if you are using an Arlo Pro base station, press the button on the top of the base station for about two seconds and then release the button.
 6. Later, wait for the sync status LED to blink green.
 7. Then press the Sync button on top of the camera for about two seconds and then release the button. 
The blue LED on the camera blinks rapidly to confirm sync. Whether LED on the camera blinks amber, the sync is not successful. You must repeat the sync process.

8. Finally, check the camera LED on the base station. If the camera LED on the base station turns solid green, the sync process is complete.

How to set up Arlo Pro Wire – Free Camera:

Firstly, open the battery compartment by pressing the latch and pulling back gently. Then insert the battery and close it. Now bring the camera within one to three feet of the base station. Do the syncing part to the base station as if you are using an Arlo Base station then press Sync button on the side of base station for about 2 seconds and then release it or if you are using Arlo Pro Base station then press the button on the top of the base station for about 2 seconds and release it.  After that wait for the sync status LED to blink green. Next, press the sync button on the top of the camera for about 2 seconds and then release the button. Here, if a blue LED comes on the camera then it confirms sync part. On the other hand, if its amber then it is not successful, you have to repeat the sync process.  Further, check the camera LED on the base station. Finally, if the camera LED on the base station turns solid green, then the process is complete. Repeat these given instructions for other cameras.

Note: Cameras must be synced one at a time.

Leave a Reply

Your email address will not be published. Required fields are marked *